SM267 2 x 16 LCD Display Module
GENERAL DESCRIPTION
The SM264 module uses a generic Two-Line by 16 Character backlit LCD module that is bonded to a microprocessor backplane that supports display information sent on a single wire. Both power and data connections are made to the host system via a standard RJ12 (6wire) flat cable. This greatly simplifies both installation and support of the display as they may be connected and disconnected with ease.
- Reduced size from the SM264/SM265 allows the display to fit within smaller locations
- Display contrast is adjusted by use of a trimmer resistor on the rear of the display.
- Character size on this module is approximately 7mm high.
- Where this display is used with the SM263 Motor Controller, it also supports an extension of the throttle wiring to two terminals on the rear of the SM267, to reduce cabling between the motor controller and the operator console area.
- A piezo beeper on the display can be used to announce alarm events or signal button presses
- Size and mounting details are described in the PDF article below titled:MECHANICAL DATA ON LCD DISPLAYS.
- The transmission and reception of data to and from this module conforms with the Alian Elect. Serial Display Command set. Details of this protocol are explained in the PDF article below titled: BASIC LCD DISPLAY MODULES.
- The SM267 uses a different microprocessor to other displays within the family, but remains functionally identical to other LCD modules.
ARTICLE: Mechanical data on Alian Elect. LCD display modules
This is a single sheet that describes the sizes and mounting hole positions of all Alian Elect. LCD display modules.
Note that it shows the mounting information as viewed from within the inside of the enclosure and not from the screen viewing side.
Note that it shows the mounting information as viewed from within the inside of the enclosure and not from the screen viewing side.
| alian_lcd_display_mech_data.pdf |
ARTICLE: BASIC LCD DISPLAY MODULES
This is a technical article in PDF form that discusses the workings of LCD display modules in general, with some specifics about the SM264 / SM265 / SM267 display modules as produced by Alian Electronics.
It discusses how these common modules are unfriendly to work with and communicate with and how the addition of an Alian Elect interface board can reduce the communications complexity to using single serial data packets.
It discusses how these common modules are unfriendly to work with and communicate with and how the addition of an Alian Elect interface board can reduce the communications complexity to using single serial data packets.
| using_lcd_displays.pdf |
_________________________________________________________________________________________________________________
PRICING INFORMATION
SM267 2 x 16 LCD Display Module (basic version)
Qty 1-9 $38.00
Qty 10+ $33.00
(last updated March 2012)
_________________________________________________________________________________________________________________
PRICING INFORMATION
- Payment can be made to Alian Electronics via EFT or Pay Pal
- All prices in $AUD and do not include the cost of freight. (Click HERE to view the Freight Information page)
- When buying from within Australia add 10% GST
- (Overseas sales are GST Free, but depending upon local policy, you may need to pay tax/duty for goods to be released by your Customs)
- When buying from within Australia by Pay Pal, add 2.4% for Pay Pal transaction fee.
- When buying from Outside Australia by Pay Pal add 3.6% for Pay Pal transaction and currency conversion fee.
- (When buying from Outside Australia using Telegraphic Transfer ( TT ) the buyer will pay transaction fees with their bank.)
- Transaction details, Freight & other charges will be shown on a Proforma Invoice supplied to you before you pay.
SM267 2 x 16 LCD Display Module (basic version)
Qty 1-9 $38.00
Qty 10+ $33.00
(last updated March 2012)
_________________________________________________________________________________________________________________
